- LIMBERT Ebon-Oak magazine stand with caned
LIMBERT Ebon-Oak magazine stand with caned side panels, an arched back splash and broad side slats inlaid with ebony squares. Partially refinished, replaced
- LIMBERT Magazine stand with two shelves,
LIMBERT Magazine stand with two shelves, arched aprons, inset top. Original finish, minor wear. Branded under bottom shelf. 29"x 18"x 14"
- LIMBERT Trapezoidal magazine stand with square
LIMBERT Trapezoidal magazine stand with square cut-outs and five shelves. Original finish, small holes in side, loose. Branded under bottom shelf. 40"
- Limbert magazine stand, #301, three shelves
Limbert magazine stand, #301, three shelves over an arched toe-board with a single vertical slat to each side, original finish, minor stains, 16"w x 10.5"d
- Limbert magazine stand, similar to #300,
Limbert magazine stand, similar to #300, in ash, four shelves supported by slab sides with a circular cut-out and single vertical spindle, raised peg construction,
- LIMBERT Magazine stand with slatted sides
LIMBERT Magazine stand with slatted sides and V toe-board. Branded mark. 42" x 16" x 12"
- LIMBERT Magazine stand (no. 303) with arched
LIMBERT Magazine stand (no. 303) with arched toe-board and top stretcher. Branded mark. 42"" x 21"" x 12""
- Arts and Crafts magazine stand similar to
Arts and Crafts magazine stand similar to Limbert #214 in mahogany rectangular top on an arched apron over a lower shelf top refinished original finish
- Arts and Crafts magazine stand in the manner
Arts and Crafts magazine stand in the manner of Limbert fourshelves with one extended shelf supported by corbels numbered#344 recoated original finish
- Limbert magazine stand #346 five shelves
Limbert magazine stand #346 five shelves supported by slab sides with cut-outs branded signature original finish 24''w x 13.5''d x 40''h very good
- Early Limbert magazine stand #217 unusual
Early Limbert magazine stand #217 unusual form with a single shelf and cut-out slab sides above a cut-out design at base refinished unsigned 12''w
- Limbert magazine stand #300 four shelves
Limbert magazine stand #300 four shelves supported by slab sides with circular cut-out and vertical spindle worn original finish some roughness signed
- Limbert magazine stand #304 four shelves
Limbert magazine stand #304 four shelves above an inverted ''V'' toe-board supported by slatted sides good original finish branded signature 16''w
- LIMBERT (Attr.) Magazine stand
Condition
LIMBERT (Attr.) Magazine stand
Condition Report: Possible older refinish. Good overall condition.
- LIMBERT; Cut-out magazine stand, Grand Rapids,
LIMBERT; Cut-out magazine stand, Grand Rapids, MI, ca. 1906; Branded mark and number; 37" x 20" x 14"
Condition Report:
- LIMBERT; Cane-side magazine stand, Grand
LIMBERT; Cane-side magazine stand, Grand Rapids, MI, ca. 1910; Oak, darker wood inlay, caning; 32" x 21 1/2" x 13 1/2"
Condition Report:
- LIMBERT; Magazine stand, Grand Rapids, MI,
LIMBERT; Magazine stand, Grand Rapids, MI, ca. 1910; Branded mark; 37" x 20 1/4" x 14"
Condition Report:
- Limbert Magazine Stand with Cutouts No. 300.
Limbert Magazine Stand with Cutouts No. 300. Mission oak, refinished. Branded mark. Signs of wear consistent with age and use with a chip to the foot.